Operator`s manual

Maintenance Section 5-11

MAINTENANCE

FL20MFL14M 10/03

MAINTENANCE

8. Install driveline yoke onto shaft and install four bolts through yoke spacers #10 and center plate #4. Install

locknuts and tighten.

9. Rotate yoke and center plate so that cotter pin #13 can be installed.

10. Tighten large nut #7 as much as possible by hand. NOTE: Make sure both springs #5 are centered on guide

ring #6.

11. Reinstall washer #15 and castle nut #14. CAUTION: Do not tighten nut #14. Tighten only enough to remove

play between the yoke, washer #15, and nut #14. Install cotter pin.

GEARBOX ARRANGEMENTS (Secondary Gearboxes)

All Three secondary Gearboxes have the same identical parts in them for 540 or 1000 RPM and for the left,

center, or right sections. To change Gearbox from 540 to 1000 RPM, the Gear (#1) and Pinion (#2) must be

reversed. Remove the Gear from the Cross Shaft and the Pinion from the vertical Output Shaft. Install the

Gear on the vertical output shaft and the pinion on the Cross Shaft. Reassemble the Gearbox allowing .008 to

.012 backlash. Repeat this procedure on all three Gearboxes. When removing the Bearings and Gears, do

not mar the Grease Seal Race. Be extremely careful when installing the Grease Seals so they will not be

damaged.

CW ROTATION

P/N 65504AL

Secondary Gearbox

Assembly

1000 RPM Input

CCW ROTATION

P/N 65504AR

Secondary Gearbox

Assembly

1000 RPM Input

P/N 65104AL

Secondary Gearbox

Assembly

540 RPM Input

CCW ROTATION