TABLE OF CONTENTS 1.0 SAFETY AND INSTALLATION 1.1 Safety Information.............................................................................. 3-4 1.2 Unpacking and positioning (before connecting to the power supply)... 4-5 1.3 Connecting the cooler to the Power Supply....................................... 6 2.0 OPERATION 2.1 Operation of the Appliance................................................................... 6 2.2 Adjustment of the temperature..................................................
1.0 SAFETY AND INSTALLATION 1.1 Safety Information WARNING! All electrical work must be carried Warning! Please observe the following safety precautions and instructions at all times: This appliance is for indoor use only. Do not use this appliance other than for its intended use as a beverage display cooler. Always disconnect the mains power supply before removing any covers, performing maintenance work, cleaning or making any repairs.
inside this appliance. Do not use any electrical appliances inside the refrigerated compartment of this appliance. Do not use any mechanical devices or other means to accelerate the defrosting process. Defrosting is performed automatically by the electronic controller and needs no user intervention. Do not damage the refrigeration circuit. If you do so, then open a window or door the insulation foam.
accordance with all local laws and regulations. Safety Note: Please pay special attention to the hazard represented by the plastic bag so that it may not be taken by children. Please take care not to pinch or damage the power cord in any way. Please examine the power cord for any splits, cuts or damage.
1.3 Connecting the cooler to the Power Supply Please observe all of the warnings and procedures stated in section 1.1. Please take care not to pinch or damage the power cord in any way. Please examine the power cord for any splits, cuts or damage. If it is unsatisfactory then it must be replaced according to the instructions stated in 1.1. Plug in the cooler and turn on the power. Switch on the appliance using the red power switch on the front control panel. 2.0 OPERATION 2.
3.0 MAINTENANCE Please observe all of the safety warnings, precautions and instructions set out in Section 1. 3.1 Lighting The appliance uses LED lighting strips powered by a low voltage transformer. If replacement is required, please order genuine replacement parts from Rhino. 3.2 Cleaning the interior and exterior The interior walls and shelves should be cleaned and sanitised on a regular basis so as to ensure hygiene regulations are met. Please do not use splashing, dripping, jetting or running water.