INSTRUCTION MANUAL DISPLAY COOLERS SGT1 SGT2 Thank you for choosing this Rhino appliance. It is essential that you read these instructions carefully and keep the booklet in a safe place for your future reference. The booklet contains mandatory safety information as well as essential maintenance routines. Failure to observe the instructions is unsafe and will also invalidate the guarantee.
TABLE OF CONTENTS 1.0 SAFETY AND INSTALLATION 1.1 Safety Information.............................................................................. 3-4 1.2 Unpacking and positioning (before connecting to the power supply)... 4-5 1.3 Connecting the cooler to the Power Supply....................................... 6 2.0 OPERATION 2.1 Operation of the Appliance................................................................... 6 2.2 Adjustment of the temperature..................................................
1.0 SAFETY AND INSTALLATION 1.1 Safety Information WARNING! All electrical work must be carried Warning! Please observe the following safety precautions and instructions at all times: This appliance is for indoor use only. Please do not use this display cooler other than for its intended use as a pre-packaged food and beverage display cooler. Cleaning and user maintenance shall not be made by children under any circumstances.
inside this appliance. Do not use any electrical appliances inside the refrigerated compartment of this appliance. Do not use any mechanical devices or other means to accelerate the defrosting process. Defrosting is performed automatically by the electronic controller and needs no user intervention. Do not damage the refrigeration circuit. If you do so, then open a window or door the insulation foam.
accordance with all local laws and regulations. Safety Note: Please pay special attention to the hazard represented by the plastic bag so that it may not be taken by children. Please take care not to pinch or damage the power cord in any way. Please examine the power cord for any splits, cuts or damage.
1.3 Connecting the cooler to the Power Supply Please observe all of the warnings and procedures stated in section 1.1. Please take care not to pinch or damage the power cord in any way. Please examine the power cord for any splits, cuts or damage. If it is unsatisfactory then it must be replaced according to the instructions stated in 1.1. Plug in the cooler and turn on the power. Switch on the appliance using the red power switch on the front control panel. 2.0 OPERATION 2.
3.0 MAINTENANCE Please observe all of the safety warnings, precautions and instructions set out in Section 1. 3.1 Lighting The appliance uses LED lighting strips powered by a low voltage transformer. If replacement is required, please order genuine replacement parts from Rhino. 3.2 Cleaning the interior and exterior The interior walls and shelves should be cleaned and sanitised on a regular basis so as to ensure hygiene regulations are met. Please do not use splashing, dripping, jetting or running water.
Household vacuum cleaner condenser 4.0 condenser IN THE EVENT OF A MALFUNCTION and skilled refrigeration service engineer and insist upon genuine Rhino parts. If the appliance is under guarantee, please call the company from whom you purchased the appliance. Always have the serial number to hand. The serial number is located on the inside wall of the refrigerated compartment. It is often accompanied by, or located next to, a bar code. 5.0 DISPOSAL AT END-OF-LIFE also within the insulation foam.
