User's Manual

Direction Finder RHOTHETA RT-400
RHOTHETA Page 6 of 18 User Manual
2.2 Basic Safety Instructions
Caution / Warning
Read and observe the following instructions, warnings and safety instructions of the
manufacturer!
• During all work, the local and national safety and accident prevention regulations
must be observed.
• When installing or operating the product always follow the manufacturer's
instructions.
• Always place the product on appropriate locations.
• Do not expose the product to environmental conditions (heat, humidity, wind load
etc.) that exceed the specified acceptable conditions in the manuals.
• Use only the manufacturer’s prescribed components and/or use only recommended
materials and do not modify them. Any other use or unauthorized modifications to
the product will void the authorization to operate it.
• Connect only approved accessories kits or additional equipment.
• Ensure that the connections with information technology equipment, e.g. industrial
computers, comply with the IEC 60950-1/EN 60950-1 or similar standards that
apply in each case.
• The product may only be opened by authorized personnel. The connector must
always be disconnected before opening.
3 Legal Information
3.1 EU Declaration of Conformity
RHOTHETA Elektronik GmbH hereby declares that the product RT-400 is in compliance with
the essential requirements and other relevant provisions of:
• Directive 2014/53/EU relating to radio equipment
• Directive 2011/65/EU on the restriction of the use of certain hazardous substances in
electrical and electronic equipment
The full text of the Declaration of Conformity can be found at:
https://www.rhotheta.com/products/rt_400
3.2 FCC Information (USA)
Changes or modifications not expressly approved by the party responsible for compliance
(RHOTHETA) could void the user's authority to operate the equipment.