Specifications

TM 9-2350-311-34-1
SECTION I. FINAL DRIVE ASSEMBLY
8-1 FINAL DRIVE ASSEMBLY
This task covers: a. Disassembly
b. Assembly
Tools
General mechanic’s tool kit (item 14, Appx C)
Fabricated stand (item 2, Appx D)
Torque wrench (item 26, Appx C)
Torque wrench (item 28, Appx C)
Cotter pin (item 13, Appx F)
Gasket (item 83, Appx F)
Gasket (item 86, Appx F)
Gasket (item 53, Appx F)
Gaskets (2) (item 54, Appx F)
Grease (item 9, Appx B)
Lockwashers (24) (item 37, Appx F)
Lockwashers (7) (item 39, Appx F)
Seal (item 84, Appx F)
Seal (item 46, Appx F)
Two
Final drive removed (TM 9-2350-311 -20-1 )
a. Disassembly
1
2
3
4
5
6
7
Remove
gasket.
Remove
gasket.
Remove
Remove
Remove
Remove
Remove
seal (1), 12 screws (2), 12 Iockwashers (3), cover (4), and gasket (5). Discard seal, lockwashers, and
seven screws (6), seven Iockwashers (7), housing cover (8), and gasket (9). Discard Iockwashers and
input splined gearshaft (10) and two bearing races (11 ).
two bearing cones (12).
cotter pin (13) and nut (14). Discard cotter pin.
ring gear (15) and spacer (16).
bearing (17).
NOTE
Step 8 applies only to leaking final drive housings.
8 Remove four screws (18), four Iockwashers (19), input shaft cover (20), and gasket (21 ) from final drive
housing (22). Discard Iockwashers and gasket.
8-2