User manual

Power Source
1 Plug the AC Adaptor (output 12V 3A) of the unit into appropriate wall outlet
2 Plug the small end of the adapter into the Adaptor Jack on the back of the unit.
General
1 Make sure the unit is plugged in correctly to an AC outlet.
2 Press the POWER button to turn on the unit .
3 Once the power is turned on, press the FUNCTION button to switch between Tuner/CD/Phono/Aux.
When switching between functions, wait one second after pressing the function button before pressing it
again. This gives the unit time to load the correct information for the selected function.
Radio Operation
1 Press the FUNCTION button to set the unit to Tuner mode
2 Press the BAND button to select the desired tuning band (AM/FM).
3 Select the desired radio station by rotating Tuning knob .
4 Adjust the volume to the desired listening level.
Antenna
Antenna: for FM reception, the unit is provided with a FM WIRE ANTENNA , move the wire until the reception is
clear and with no interferences. For AM reception, the unit is provided with a directional build-in ferrite antenna.
Rotate the set to find the position in which the best reception is obtained. Do not connect the EXTERNAL FM
ANTENNA to any outside antenna.
USB Operation
Using the included software and cable, the USB connection allows you record your records onto your computer.
Follow these instructions to use the USB.
1 Insert the enclosed software CD into your computer.
2 Follow the instructions on the computer screen to install the software. If the software does not load
automatically, browse the software CD and open the "Readme.html" file. Follow the instructions on the main
menu.
3 Connect the square end of the cable to the JACK on the back of the unit.
4 Connect the other end to a USB port on your computer.
5 On your computer, open the Record Recording Software.
6 For instructions on operating the Record Recording Software, browse the software CD and open the
README.html .
Turntable Operation
1 Press the FUNCTION button to set the unit to Phono mode.
2 Set the SPEED CONTROL SWITCH to the correct speed (331/3, 45 or 78 rpm) for the selected record.
3 Use the CUE LEVER to raise the tone arm off its rest. Move the tone arm over the record and use the
cue lever to lower it to the point you want the record to start.
4 At the end of the record, the tone arm will return to its rest.
NOTE:The turntable and cassette players both operate in the same mode. Make sure the cassette player is in
STOP mode when listening to a record.
Accessory:ADAPTER FOR 45 RPM
To play the 45rpm record, place the ADAPTER on the spindle.
Playing a Cassette
1 While in Phono mode, press the STOP/EJECT button on the cassette player to open the cassette door.
2 Insert a prerecorded cassette tape into the cassette door.
3 Press the PLAY button to begin play.
4 To stop playback, press the STOP/EJECT button.
5 Press the STOP/EJECT button again to eject the cassette.