Vacuum Cleaner User Manual

Operation

Replacing headlight bulb

CAUTION: Disconnect the vacuum cleaner from the

electrical outlet before replacing bulb.

1. Remove bottom plate (See “Removing and

reinstalling bottom plate”).

2. Remove the headlight bracket by pulling upward

on bracket [Fig. 19]. To remove the light bulb, pull

straight out of socket. To install new bulb, simply

push bulb straight into socket for a secure fit.

Reinsert bracket back into nozzle.

3. Re-install bottom plate (See "Removing and

reinstalling bottom plate").

Replacing agitator belt

CAUTION: Disconnect the vacuum cleaner from the

electrical outlet before replacing belt.

1. Remove bottom plate (See “Removing and reinstalling

bottom plate”). Remove vented support fitting

[Fig. 20] and belt guard [Fig. 21].

2. Take out the agitator assembly and remove worn or

broken belt from agitator pulley and motor drive

shaft [Fig. 21].

3. Loop new belt around the agitator pulley and the

motor drive shaft and re-insert the agitator assembly

back into the housing. Turn the agitator assembly

by hand, making sure the belt is not twisted and all

rotating parts move smoothly [Fig. 22].

4. Re-insert the vented support fitting and belt guard,

making sure that they are in place before fastening

the bottom plate to the two ribs at the front of the

housing. Re-install bottom plate.

NOTE: To ensure maximum cleaning efficiency, the

condition of the belt should be checked regularly. If belt

is stretched, cracked or if excessive slipping is occurring,

replace the belt.

Fig. 19

Fig. 20

Fig. 21

Fig. 22