Service manual

10 Multiple Animal Scale Portable - Installation Manual
2.4.3 Install the Gate
Install the gate with the hinge bolts on the opposite side of the scale.
Hinge bolts must be assembled with lock washer on the inside of gate and the jam nut on the outside.
Figure 2-4. Assemble Gate to Scale
1. Install jam nut and lock washer onto the hinge bolts. Screw the nut on about 2”.
2. Insert one hinge bolt into the lower and upper holes of the cage wall with the hook portion pointing
upward.
3. Install nut and washer onto the hinge bolts securing them to the cage wall.
4. Place nylon washer onto the hook portion of the upper and lower hinge bolts and install the gate onto the
hooks.
5. Insert roll pin through the hinge bolts.
6. Repeat steps 2-4 for second gate.
7. Adjust the hinge side gap between the gate and the cage wall to about 3” and snug hinge bolts.
Note
Hook Bolt
Spring Pin
Nut and washer
Cage Wall
Gate
Jam nut
Nylon washer
Install Spring Pins after
gate is in place.
Washer