User`s manual

- 12 -
It show the name of the equipment, and users can name the Slave KVM or PC on their own.
There are a total of 12 characters selected from the group of “A~Z”, “a~z”, “0~9” , “＋”,
“－” , “＊”, “／” , “＝”, “［”, “］”, “，”, “．”, “：”.
Note：Please use the Caps Lock to toggle between the upper and lower cases.
5.SVS：
It shows the Smart View Setting; use to open ♁ and Θ to close. The SVS is blank and cannot
be clicked if the KVM is connected in parallel.
If this option is set to open, then you can make the switch by operating the Hot Key Switch or
Mouse Clicking or selecting the option by Auto Scan. You also can use mouse to click this
field.
6.Selection BAR：
It shows the selection bar (Green); you can use the ↑↓ keys on the board to move the selection
bar, and the situated position indicates the selected target for giving instructions. For example,
if the selection bar points at C#05 and you press Enter, then the system will switch to that
particular PC or press the “Space BAR” to start editing the name. Press F4 to enable/disable
the SVS option.
Instruction Hint Field：
1.) *↑↓：Move
Use the ↑↓ keys on the keyboard or the mouse to move the selection bar.
2.SPACE：Edit
The “Space BAR” on the keyboard is used to start editing the name of the PC or KVM.
3.ESC：Exit
Use the “Esc” key on the keyboard to exit the current option or exit OSD.
4.F4：Auto Scan
Use the F4 key to run Auto Scan, and you can set the residing time, channel display time and
mode of the Auto Scan from System Setting.
5.F9：System Setting
Use the F9 key to enter into the System Setting Menu.
6.F5：Clear Name List
Use the F5 key to clear the value of all Name fields. If you clear the name list under the
Master screen, then you will also clear the name list under all slaves. If you clear the name list
under a certain slave, then you only clear the name list under that particular Slave KVM.
7.F1：Smart View
It switches the Smart View Setting.