User's Manual

Bluetooth Speaker
Model 122
1.Mode. When powered on it will automatically enter Bluetooth mode.Short press to skip to Aux mode.
2.Volume Down/Previous.Short press to skip to the previous music.Long press to decrease volume.
3.Play/Pause/Call. Press to play and pause music.Press to answer or hang up incoming phone
call.Quick press twice to call back to the last incoming call.
4.Volume Up or Next.Short press to skip to the next music.Long press to increase volume.
5.Charging indicator light.When charging,the LED indicator will turn red.
6.Micro SD/TF: Insert your TF card.You can listen to MP3 music stored in TF card(supports maximun
capacity of 16GB).
7.Power on/off.Slide to “on” to start the Bluetooth speaker. Slide to “off” to turn off.
8.MIC.Microphone for hands free phone calls.
9.USB/AUX input connector.Use the USB cable(included) to charge. Connect the speaker and the
mobile phone with USB /Aux in cable(included) to play the music stored in the phone.
10.3.5 mm headphone jack. Insert your headphone with 3.5mm jack(not included).You can listen to
the music stored in TF card or on USB flash.
11.USB flash. Insert your USB flash.You can listen to MP3 music stored on USB flash.
FCC Warning Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
--Consult the dealer or an experienced radio/TV technician for help.
Location of Controls
Bluetooth Speaker Pairing / Reconnecting
1. Turn the speaker On.When powered on it should automatically enter Bluetooth mode.If
it does not,press the Bluetooth button.
2. Now, turn ON the Bluetooth function of your device.
3. For the first time pairing a new mobile device,search for “BT122” and select it to begin
Bluetooth pairing.
4. The speaker will reconnect automatically if your mobile phone has been paired previously.
(Note:Depending on the device’s type and configuration,manual reconnection may be
required each time.)
5. If pairing is successful,you will hear the tone “the device is paired” to confirm.
6. Slide to the Power Off to turn the unit Off.
(Note:If you can not search for the speaker,this means the last device is reconnecting
automatically.Try again to pair with speaker.)
Specifications
Bluetooth version: EDR+2.1
Working range: up to 33 ft.
Dimensions: 2-3/8” x 2-3/8” x 2-1/4”
Net weight: 6 oz.


Frequency Response: 280HZ-16KHz
!"
#$%&'
Battery Capacity: 300mAh
"()*,#),%%57
Charging The Bluetooth Speaker
1. Make sure the unit is in Off mode.
2. Connect the Bluetooth Speaker to the Computer with the USB cable (included).
3. When charging,the LED indicator will turn red.
4. Charge for 2-3 hours to fully charge the rechargeable battery.
5. When charging is completed, disconnect the USB cable.
Hands Free Function
1. When you have an incoming call, a message sounds. It will announce “the phone number”
of the person who is calling you and the playing music will pause automatically.
2. Press the Play/Pause button (3) to answer the call.
3. Now you have the hands free function with the Bluetooth speaker.
4. Press the Play/Pause button again to hang up the call and music will resume normal
playback.
NOTE: Speak into the MIC Hole (8) directly within 2”-4” distance to get the best speakerphone
performance when desired.
)5217
%$&.
5,*+7 6,'(

86%)ODVK-DFN
86%$8;LQSXW
FRQQHFWRU

PP+HDGSKRQH-DFN
2)
)
21
0,&
0LFUR6
'7
)
3RZHU2Q2II
0,&
92/ 3UHYLRXV
0RGH
&KDUJLQJ,QGLFDWRU
/LJKW

92/ 1H[W
3OD\ 3DXVH&DOO

Summary of content (1 pages)