HANDSET HJH55 Ble
1. Remark: 1.Radio frequency handset 2.2x1.5V batteries 3.Effective distance: within 5m 4. Frequency range:2.402GHz-2.48GHz. 2.
. Remote control button diagram ZG SNORE TV Head（mm） 31 18 114 Foot（mm） 79 0 46 4.Remote control function description Button label 1 2 function The bed bottom lamp is on/off (constant light). Flashlight on/off (default 15s). Reuse function: ①Press and hold the button for 5s, the backlight flashes, enter the memory mode, press ZG/SNORE/TV/M1/M2 within 2s, the buzzer "dididi" will sound, and the current motor position, massager, and light bar can be memorized state.
3 4 5 6 7 8 9 10 11 12 13 settings at the same time. ③Press and hold FLAT+flashlight for 3s at the same time, the backlight flashes three times, the buttons on all positions of the remote control enter the continuous pressing mode, release the button and the motor stops. FLAT one-key reset, all motors retract to the minimum stroke position, turn off the bed light, massager (no reset after power on) The head motor extends. The motor runs to the ZG position with one key (there is an initial value).
14 15 16 17 18 massager is the strength when the massager was closed last time. If the massager is turned on, press the button to increase the strength of the head massager. There are 3 intensities, according to: Low->medium->high order, the default time is 15 minutes, and it will continue to run when it reaches the highest intensity.
buttons (7, 6) of the remote control 1 until you hear the buzzer sound and the backlight flashes, indicating that the remote control 1 is successfully paired; do not press any buttons on the remote control 1, keep pressing the remote control The head down and foot up buttons (7, 6) of the controller 2 until the buzzer sounds and the backlight flashes, indicating that the remote controller 2 is successfully paired.
Caution: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
