Copier User Manual

Chapter 3
3 - 6
Dual Access
You can dial a number, and begin scanning
the fax into memory—even when the
machine is sending from memory, receiving
faxes. The LCD shows the new job number.
Note
■ The number of pages you can scan into
the memory will vary depending on the
data that is printed on them.
■ If you get an Out of Memory message
while scanning the first page of a fax,
press Stop/Exit to cancel scanning. If
you get an Out of Memory message
while scanning a subsequent page, you
can press Start to send the pages
scanned so far, or press Stop/Exit to
cancel the operation.
Real Time Transmission
When you are sending a fax, the machine will
scan the documents into the memory before
sending. Then, as soon as the phone line is
free, the machine will start dialling and
sending.
If the memory is full, the machine will send the
document in real time (even if Real Time
TX is set to Off).
Sometimes, you may want to send an
important document immediately, without
waiting for memory transmission. You can set
Real Time TX to On for all documents or
Next Fax:On for the next fax only.
1 If it is not illuminated in green, press
(Fax).
2 Press Menu/Set, 2, 2, 5.
3 To change the setting, press ▲ or ▼ to
select On, Next Fax:On,
Next Fax:Off or Off.
Press Menu/Set.
5.Real Time TX