Owners manual
127
5. Using On-Screen Menu
TIP:
Clearing the digital certicate that is installed on the projector
To clear the digital certicate installed on the projector, follow the steps below.
By doing the following procedure, all the digital certicates for the currently displayed prole will be cleared.
1. Select [CLEAR CERTIFICATES] in the bottom left of the [AUTHEN-
TICATION] setting screen and press the Enter button.
A message for conrmation will be displayed.
2. Select [YES] and press the Enter button.
The digital certicates will be cleared.
TIP:
Entering WEP keys (Switching between Alphanumeric characters and hexadecimal)
To enter from [KEY1] to [KEY4], do the following:
1. Select one of [KEY 1], [KEY 2], [KEY 3] and [KEY 4] and press the Enter button.
The character entry screen (software keyboard) will be displayed.
2. Use the , , , or button to select a character and press the Enter button.
• To enter a WEP key or passphrase, use alphanumeric characters (ASCII) or hexadecimal (HEX). To enter a PSK
key, use alphanumeric characters (ASCII).
• Press the [HEX] button to change to [ASCII] to set the key in ASCII digit. You can toggle this button between
[ASCII] and [HEX].
• Enter 0x(numeral and alphabet respectively) right in front of your key code.
• Hexadecimal uses 0 to 9 and A to F.
3. After entering your WEP key or passphrase, use the , , , or button to select [OK] and press the Enter
button.
The character entry screen (software keyboard) will be closed.