Facsimile Operating Instructions

GETTING STARTED
16
1
Paper Size and Scanned Area
❖
❖❖
❖
Exposure glass
❖
❖❖
❖
Document Feeder (ADF)
Limitation
❒ There may be a difference in the size of the image when it is printed at the des-
tination.
❒ If you set an original larger than DLT/A3 on the exposure glass, only the
DLT/A3 area is scanned.
Note
❒ Even if an original is correctly placed on the exposure glass or in the Docu-
ment Feeder (ADF), a margin of 3 mm around each edge of the original may
not be sent.
❒ If the receiver uses paper narrower than the original, the image will be re-
duced to fit the paper width. ⇒ P.99
“Auto Reduction”
❒ The machine detects paper sizes in the following ways.
• When you set an original in the Document Feeder (ADF), an original wider
than about 7.48” is scanned as LT/LG size wide. An original wider than
about 10.37” is scanned as DLT size. Originals narrower than 9.05” will be
sent as LT/LG size. You can scan in originals of up to 17” in length.
A3
A3A4
Horizontal size
Vertical size
Reference
position
Maximum Scanning area
A3 (297x420mm)
11"x17" (279x432mm)
CP01AEE0
A3A4
Horizontal size
Vertical size
Maximum Scanning area
(297x432mm)
CP02AEE1