Facsimile Operating Instructions

PRINTING FUNCTIONS
65
3
Multi-copy Reception
The Optional Fax Feature Expander is re-
quired to use this function.
If you switch this feature on, multiple
copies of each incoming fax message
will be printed. You can also choose
to have multiple copies made of mes-
sages from particular senders. ⇒
P.161
“INITIAL SETUP RX”
, P.182
“Special Senders to Treat Differently
(Special RX Nos.)”
Limitation
❒ The maximum number of copies
that can be made of each message
is 10. If you are using Multi-copy
with Specified Senders, the maxi-
mum number is 10.
Note
❒ By default this feature is turned
off. Switch it on and set the num-
ber of copies with the Initial Setup
RX. ⇒ P.161
“INITIAL SETUP RX”
❒ Note that the machine will use
Memory Reception for Multi-copy.
2-Sided Printing
An optional Duplex Tray and Fax Fea-
ture Expander are required to use this
function.
With this option installed, you can
have a received message printed on
both sides of the paper. By default,
this feature is turned off. Switch it on
with the Initial Setup RX and select
lengthwise L copy paper. ⇒ P.161
“INITIAL SETUP RX”
Limitation
❒ To use this function all pages of the
received document must be of the
same size-inform the sending par-
ty of this beforehand if necessary.
You must also have paper set in
your machine of the same size as
that sent by the sending party
(A4→A4, B4→B4 are typical exam-
ples, whether A3 and B5 sizes are
scanned in correctly will depend
on the fax machine). This machine
will scan in correctly landscape
A3,B4,A4,B5 and portrait A4, B5
and A5. The table below shows the
results that can be achieved when
ND1X00E7
ND1X00E8