Facsimile Operating Instructions

KEY OPERATOR SETTINGS
183
7
Note
❒ If you receive a fax with a paper
size different from that set in the
paper cassette, the printout will
be split across several pages or
reduced to fit on the paper.
❒ If you choose the optional By-
pass Feed Tray, make sure the
size you programmed for this
tray matches the paper size in
this tray. For more details, P.14
“Acceptable Original Sizes”
.
• Memory Lock
*1
You can have messages received
into memory. To print them out,
P.114
“PRINTING A FILE RE-
CEIVED WITH MEMORY LOCK”
.
• 2-Sided Printing
*2
Print on both sides of the paper.
Limitation
❒ The function requires both the
optional Duplex Unit and Fax
Memory Board.
• Reverse Printing
*1
You can have pages printed in the
opposite order in which they were
received.
You can adjust the following set-
tings for this function:
• Specified Senders (maximum of
30, up to 20 characters each with
G3, up to 24 characters each
with G4)
• Wildcards P.213
“Wild Cards”
*1
The optional Fax Feature Expander is
required.
*2
Duplex Tray option and Fax Feature
Expander are required
Important
❒ It is recommended that you print
the Sender/Specified Number list
and keep it when you register or
change a sender. ⇒ P.158
“RE-
PORTS/LISTS”
Limitation
❒ The Special Reception Numbers
function cannot used to treat mes-
sages received from a Specific
Senders if they are received with
Polling Reception or Free Polling.
❒ You cannot register a Specific
Sender who does not have an RTI
or CSI.
❒ You can register up to 30 senders
for Forwarding, Special Reception
Numbers, and Authorized Recep-
tion functions. You sometimes can-
not register 30 senders depending
on the number of senders regis-
tered with other functions. If you
install the optional Fax Feature Ex-
pander, you can register up to 50
senders.
Note
❒ To register a sender, use an RTI or
CSI. When you communicate with
a sender using G4, register a G4
TID
❒ You can find the RTI or CSI of a
sender by looking in the destina-
tion name column of the TCR
❒ Before using the Special RX Nos.
function, switch this function to
On by following the steps shown
in Initial Setup RX. ⇒ P.161
“INI-
TIAL SETUP RX”
Registering Specific Senders (Special X
Nos.)
A Make sure that the machine is in
Facsimile mode and the standby
display is shown.