Operation Manual

DRAFT 2003/11/12
Troubleshooting
70
3
Out of specified pa-
per
Load ***mm width pa-
per
The ratio set in Auto Paper Se-
lect is different to the size of
the copy paper size.
• Check the settings for Re-
duce/Enlarge, etc., and
then try again.
• Set paper of a suitable
width.
Check settings
Copy paper size and original
size is different.
Check the settings for Re-
duce/Enlarge, etc., and then
try again.
Cannot rotate sort
this size orig.
Set other original,
or press[Change] and
cancel rotate sort.
The scanned original is too big
to rotate.
You cannot use rotate sort
with A0 (E) originals.
An unsuitable paper size for
rotate sort has been set.
Set paper of the following di-
mensions: A2 594 × 420 mm,
A3 420 × 297 mm.
❖
❖❖
❖ Inch version (Engineer-
ing)
• 11" × 17"
• 17" × 22"
• 22" × 34"
❖
❖❖
❖ Inch version (Architec-
ture)
• 12" × 18"
• 18" × 24"
• 24" × 35"
Max. Copy Quantity:
NN
The number of copies exceeds
maximum.
Change the maximum copy
quantity you can make at a
time. See p.86 “Max. No. of
Sets”.
Some settings cannot
be changed. Press
[Re-scan] and reset
original to copy
with current set-
ting.
Function that cannot be
changed are set in Additional
Copy.
Check the settings, and then
use Additional Copy again.
Open the part as
shown and
remove
original.
The original has jammed
(original misfeed).
Follow the on-screen instruc-
tions to remove the jammed
original. See “x Clearing Mis-
feeds”, General Settings Guide.
Open the part as
shown and
remove pa-
per.
The copy paper has jammed. Follow the on-screen instruc-
tions to remove the jammed
paper. See “xClearing Mis-
feeds”, General Settings Guide.
Open the Rear Cover
and remove paper.
Message Problem/Causes Solutions