Operation Manual

DRAFT 2003/11/12
If You Cannot Make Copies As You Want
75
3
If You Cannot Make Copies As You Want
This section explains causes of, and solutions for, unexpected copy results.
Problem Causes Solutions
Misfeeds occur frequently. The size of paper is different
to that of the tray.
Adjust the tray to the size of
paper.
Jammed or torn paper is in-
side the machine.
Remove the paper. See
“xClearing Misfeeds”, Gener-
al Settings Guide
.
The paper is curled. Smooth out the curl and try
again.
Images are cropped when us-
ing Erase Border.
The Erase Border setting is too
big.
The margin of the original is
too small.
Reduce the size of the Erase
Border setting. See p.45 “Erase
Border”.
Parts of the image are not cop-
ied.
The original is not placed cor-
rectly.
Place the original correctly.
See p.16 “Placing Originals”.
An improper size of paper is
selected.
Select the proper paper. See
“Copy Paper”,
General Set-
tings Guide.
Shift or Margin Adjustment
mode is selected.
Cancel Shift or Margin Ad-
justment mode. See p.43
“Margin Adjustment” and
p.44 “Shift”.
Copies are blank. The original is not set correct-
ly.
Place the original with the sur-
face to be copied on face
down.
Copies shift sideways. The paper roll is not set cor-
rectly.
Set the paper roll correctly,
making sure it is straight and
not loose. See “CLoading Pa-
per Roll”, General Settings
Guide
.
The original does not match
the size in the original table
setting.
Adjust the original guides to
the specified size, and then in-
sert the original along the
guides. See p.16 “Placing
Originals”.
The paper is not set correctly
in the bypass tray.
Make sure the paper size
matches the bypass tray
guides. See p.26 “Copying
from the Bypass Tray”.