Operating instructions

User Tools
108
5
6 Administrator Tools
7 Onine Settings
Limitation
❒ The optional PC controller is required.
❖ User Codes
If user codes are turned on, operators must enter their user codes before they can operate
the machine. The machine keeps count of the number of masters and prints made under
each user code. See “3 Set User Code” below.
1 Display Counter(s) You can check the number of masters and copies made under
each user code.
2 Clear Counter(s) You can clear each or all user code counters.
Reference
To clear the number of masters and copies, see p.110 “Clear-
ing the Counter”.
3 User Code
Management
You can select whether or not to use User Code mode.
Note
❒ Default: Do not Use
4 Key Counter Adjust Normally, the optional key counter counts the number of prints
regardless of the number of masters used. You can, however,
add to the key counter a value between 0 and 50 to the key
counter each time a new master is used.
Note
❒ Default: 0 time
❒ Range of adjustment: 0–50
No. Mode Description
1 Hold Data-in You can select to have Hold Data-in mode either “On” or “Off”
when the power is turned on, or after mode settings have been
cleared.
Note
❒ Default: Off