Operating instructions

Troubleshooting
68
4
Printing Problems
Printing Problems When Using Combine Mode
Problem Cause Action
When you try to select several
functions at the same time,
some of them cannot be select-
ed.
Some functions cannot be
used together.
See p.66 “Combination
Chart”.
Parts of the image are not
printed in Edge Erase mode.
The edge erase margin that
you set is too wide.
Adjust the edge erase margin
with the user tools. See “Erase
Border Width” on p.106 “4 In-
itial Settings”.
The original has very narrow
margins.
Prints are blank, or parts of
the image are not printed.
The paper feed side plates are
not set correctly.
Make sure that the paper feed
side plates touch the paper
lightly.
Printing in a second colour is
unsatisfactory.
The first colour is still wet. Wait until the first colour be-
comes dry.
An uneven solid image ap-
pears.
Large solid image wrinkles
the master.
Increase the printing speed or
use Photo mode.
Problem Cause Action
Prints are blank or parts of the
image are not printed.
Original size and orientation
are not correct.
You cannot combine originals
of different sizes and orienta-
tions
The image is not printed cor-
rectly.
The originals were fed in the
wrong order.
When using the optional Auto
Document Feeder, place the
originals face up. The first
original should be on the top.
When using the exposure
glass, place the originals face
down on the exposure glass.
The first original should be
placed first.