Extra Information

36
Follow the procedure below to check the position of the subject
on the LCD monitor and adjust the focus.
■ LCD monitor
● Shooting scope
Position your subject in the middle of the LCD monitor.
● Autofocus field
This is the field in the middle of the LCD monitor, as
shown in the figure, within which the focus is
automatically adjusted.
■ Shutter release button
The shutter release button works in a two-step action.
● Press halfway
When you press the shutter release button lightly
(halfway), the autofocus function is triggered and the
camera is focused on the subject.
Adjusting the Focus
• The dotted lines and shaded
area indicated on the LCD
monitor are for explanatory
purposes only. There are no
actual dotted lines or shaded
area.
Note
• If the autofocus LED blinks,
the subject is out of focus. If
this occurs, use the focus
lock function. See “Focus
Lock Shooting” (p.44).
• If the [SLOW SHUTTER]
message is displayed, take
care to avoid moving the
camera as the shutter speed
will be slow. You are also
recommended to use the
flash. See “Flash Mode”
(p.50).
• If [!AE] is displayed, the
image is overexposed, but it
can be recorded by pressing
the shutter release button
fully.
Note