Specifications

Disassembling, Assembling & Adjustment 6-21
M M L 0 0
6.2.5. Removal of the Up-down Wire
Applicable jigs and tools: +Screwdriver, Push-pull Gauge.
[Disassembling Procedures]
1. Remove the Following parts:
Rear Cover (Refer to item 6.1.2 on page 6-2)
Front Cover (Refer to item 6.1.4 on page 6-4)
Front Side Cover
Main Tray
2. Remove the four wire-bracket screws (2 screws at the front wire bracket and 2
screws at the rear wire bracket), and take off the Up- down Stay.
Figure 6-33. Removal of the Up-down Wire
3. Remove the E-ring and the Lower Up-down Pulley and remove the wire.
Figure 6-34. Removal of the Up-down Wire
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
CAUTION:
The following procedure shows replacement of the rear wire Removal of the front wire
is similar, but relationships are inverted (mirror image).
CAUTION:
There is a pin located in the inside of the pulley. Take care to avoid losing the pin when
removing the pulley.