Specifications

6-28 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.2.9. Removal of the Paper Feed Roller and the Feed Roller
Applicable jigs and tools: +Screwdriver.
[Disassembling Procedures]
1. Remove the sub-tray and the cover A. (Refer to item 6.2.8 on page 6-27)
2. Remove the 2 Stop rings, Then shift the left and right bearings outside, and
remove the feed roller.
Figure 6-47. Removal of the Paper Feed Roller and the Feed Roller
3. Pull out three stop rings, the three bearings, the actuator and two shaft of the
feed-roller unit then remove each roller.
Figure 6-48. Removal of the Paper Feed Roller and the Feed Roller
[Assembling Procedures]
1. Reinstall the Paper Feed Roller and the Feed Roller reversing the procedure
above.
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
CAUTION:
Ensure that the mounting direction of the rubber is correct.