Specifications

6-30 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.3. Adjustment
6.3.1. Adjusting of the Magnets on the Conveyance Guide Plate B
Applicable jigs and tools: +Screwdriver.
[Preparation]
1. Open the front cover.
2. Check whether the Conveyance Guide Plate B makes contact with the cushioning
rubber when the magnets are stuck to the Conveyance Guide Plate A.
3. If the plate B does not make contact with the cushioning rubber, remove the Rear
Cover and carry out adjustment as described below.
[Adjustment Procedures]
1. Remove the Rear Cover. (Refer to item 6.1.2 on page 6-2)
2. Detach all FNS 108H P/K connectors and Remove the wiring from the clamps.
3. Remove the two +screws holding the FNS 108H P/K. Remove the FNS 108H P/K
together with its bracket.
Figure 6-50. Adjustment of the Magnets on the Conveyance Guide Plate B
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.