Specifications

Disassembling, Assembling & Adjustment 6-33
M M L 0 0
6.3.3. Adjusting of the Sub-tray Paper Exit Gate
Applicable jigs and tools: +Screwdriver, Scale.
[Adjustment Procedures]
1. Remove the Rear Cover. (Refer to item 6.1.2 on page 6-2)
2. Remove the FNS 108H P/K. (Refer to item 6.3.1 on page 6-30)
3. With SD2 (sub-tray paper exit) OFF, measure the gap between the sub-tray gate
and the guide plate (indicated by A in the illustration).
Spec value for gap: A = 3.5±0.5mm.
4. With SD2 ON, measure the gap between the solenoid plunger and the bracket
stopper (indicated by B in the illustration).
Spec value for gap: B = 5±0.5mm.
Figure 6-53. Adjustment of the Sub-tray Paper Exit Gate
5. If either gap is out of spec, carry out adjustment as described below.
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.