Specifications

6-42 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.3.9. Adjusting the Paper Exit-Opening Lower Guide Plate
Applicable jigs and tools: +Screwdriver, Scale.
[Adjustment Procedures]
1. Remove the Rear Cover. (Refer to item 6.1.2 on page 6-2)
2. Remove the Top cover. (Refer to item 6.1.4 on page 6-4)
3. Remove the Cover Sheet Feeder (if installed). (Refer to item 6.2.7 on page 6-26)
4. With SD4 (paper exit-opening solenoid) OFF, confirm that the paper exit-opening
lower guide plate is a sufficient distance (distance A) higher than the sponge roll-
ers.
Spec value: A = 1.5mm and greater.
Figure 6-64. Adjustment of the Paper Exit Opening Solenoid
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.