Specifications

6-44 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.3.10. Adjusting the Tension of the Stacker Paper Exit Belt
Applicable jigs and tools: +Screwdriver, Push-pull gauge.
[Preparation]
1. If the belt tensioner has been loosened as a result of belt replacement or for some
other reason, adjust as described below.
[Adjustment Procedures]
1. Loosen the 4 set screws (see illustration).
2. Using the push-pull gauge, pull the belt-tensioner pulley shaft so that tension A is
at the value indicated below. Maintain this tension while retightening the screws.
Spec value for tension: A = 2kg.
Figure 6-67. Adjustment of the Tension of the Stacker Paper Exit Belt
[Assembling Procedures]
1. Reinstall the parts above reversing the procedure above.
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.