Specifications

6-46 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.3.12. Adjusting the Mount Location of the Upper Alignment Plates
Applicable jigs and tools: +Screwdriver, Scale.
[Adjustment Procedures]
1. Open the front cover and pull out the stacker/stapler unit.
2. Move the upper alignment plates into home position. (Move so that the actuator
on the upper alignment plate drive belt is at PS8 (upper alignment plate HP).
Figure 6-69. Adjustment of the Upper Alignment Plate
3. Loosen the 2 set screws fixing the upper alignment plates in place (one screw on
each plate),and adjust the plates so that distances A and B are within specifica-
tion.
Spec values: A = 337±0.5mm
B = 41.2±0.5mm
4. Retighten the screws.
Figure 6-70. Adjustment of the Upper Alignment Plate
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.