Specifications

6-48 DDP92/184 Finisher Maintenance Manual
M M L 0 0
6.3.14. Adjusting the Mount Location of the Lower Alignment Plates
Applicable jigs and tools: +Screwdriver.
[Adjustment Procedures]
1. Open the front cover and pull out the stacker/ stapler unit.
2. Move the lower alignment plates into home position.
(Move so that the actuator on the lower-alignment-plate drive belt is at PS24
(lower-alignment-plate HP).
3. Loosen the 2 set screws fixing the lower alignment plates in place (one screw on
each plate),and adjust the plates so that distances A and B are within specifica-
tion.
Spec values: A = 337±0.5mm
B = 40.4±0.5mm
4. Retighten the screws.
Figure 6-72. Adjustment of the Mount Location of the Lower Alignment Plates
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.