Specifications

Troubleshooting 5-13
M M L 0 0
5.2.4. E00D SUB TRAY FULL
Figure 5-8. Error Code E00D
5.2.5. E019 LOW STAPLE (R)
E01A LOW STAPLE (F)
PRIMARY FACTOR; Detected that the Sub Tray Full PS is turn ON (H).
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs.
1. The Sub-Tray is full. Remove: Paper
2. Stacker full is
detected though
the Sub-Tray is
not full of paper.
1. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN1 - PS36
2. Sensor fault. Replace:
Sub-Tray Full PS (PS36) 3.4, 3-3
3. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
PRIMARY FACTOR; E019: Lack of Rear Side Staple
E01A: Lack of Front Side Staple
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs due to a
lack of staples.
(the number of
staples is less
than 50)
1. Lack of Staples. Supply the Staple.
2. This phenomenon
occurs though the
staple plates are
in the Staple
Cartridge. (more
than 50 staples)
1. The Staple Cartridge
housing is incorrectly set.
Reset the Staple Cartridge
housing correctly.
2. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector
CN24 - M22
CN28 - M24
3. Staple Detection Sw in
Stapler is fault
Replace:
Stapler Motor R (M22)
Stapler Motor F (M24)
3.5, 3-7
3.5, 3-7
4. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7