Specifications

Troubleshooting 5-17
M M L 0 0
5.2.8. E064 to E068 PAPER ON PAPER PATH 14 to 18
E069 to E06C PAPER ON PAPER PATH 30 to 33
PRIMARY FACTOR; Detected that sensor of each sensor unit is turn ON. This status is generally detected when
paper is in the finisher.
Note: When the center stapling/folding mode is canceled, the paper remains
in the Stacker unit and E067 is reported.
PHENOMENON CAUSES & CHECK POINTS CORRECTIONS Maintenance
Ref + Page
1. This phenomenon
occurs.
1. Paper jam occurs. Remove: Jammed Paper
2. The Sensor
detected the
paper jam though
a paper jam does
not occur.
1. Foreign substances are in
the Paper Path.
Remove: Foreign substances
2. The mounting of the
Sensor is faulty.
Reset the Sensor correctly.
3. The breaking of cables or
the disconnecting of
connectors.
Repair the cable or reset the
connector. (see the table)
4. Sensor fault. Replace: Sensor (see the table)
3.4, 3-3
5. PCB fault. Replace: FS-108H/HBM P/K 3.5, 3-7
Item
Error
Code
Sensor to be specified Maint.
Ref.
+ Page
Sensor Name Connector No. Sensor Description
(1) E064 PS4 CN1 FIN Entrance Passage PS
3.4, 3-3
(2) E065 PS6 CN1 Paper Exit 1 PS 3.4, 3-3
PS10 CN1 Paper Exit 2 PS 3.4, 3-3
(3) E066 PS5 CN1 Stacker Conveyance Passage PS 3.4, 3-3
(4) E067 PS20 CN25 Stacker No-Paper Detection PS 3.4, 3-3
(5) E068 PS1 CN1 Sub-Tray Paper Exit PS 3.4, 3-3
(6) E069 PS26 CN9 Folding Passage PS/2 3.4, 3-3
(7) E06A PS28 CN9 Folding Passage PS/1 3.4, 3-3
(8) E06B PS25 CN9 Folding Paper Exit PS/2 3.4, 3-3
(9) E06C PS201 CN51 Sheet Passage PS 3.4, 3-3