User's Manual

Solving Problems
77
4
Solving Problems
This table lists some common problems and their solutions.
Problem Required Action
Printed or sent image contains spots. The Document Feeder (ADF) or scanner is dirty. Clean
them.
Make sure that ink or correction fluid is dry before set-
ting the original.
Reference
See p.110 Cleaning the Scanner,
Advanced Fea-
tures
.
Received image is too light. Request the sender to increase the image density.
When using moist, rough or processed paper, the
printed image may be hard to see. Only use recom-
mended paper.
Reference
See p.125 Originals,
Advanced Features
.
When
D
appears on the display, toner is beginning to
run out. Replace the toner cassette soon.
Reference
See p.115 Replacing the Toner Cassette,
Advanced
Features
.
Message appears blank at the other
end.
The original was set upside down. Set it properly.
Reference
See p.23 Setting Originals.
You want to cancel a Memory Trans-
mission.
If the original is being stored, press the
{
{{
{Clear/Stop}
}}
}
key.
Reference
See p.27 Canceling a Memory Transmission.
If the original is being sent, use "Cancel TX/RX" in the
Job Information menu.
Reference
See p.11 Canceling Transmission or Reception,
Advanced Features
.
You want to cancel an Immediate
Transmission.
Press the
{
{{
{Clear/Stop}
}}
}
key.
Reference
See p.31 Canceling an Immediate Transmission.
StellaF15_EN_Combine_F1_Pre_FM.book Page 77 Friday, August 27, 2004 6:22 PM