User's Manual

ManualsBrandsRicoh ManualsFax MachineRicoh Facsimile 3725e/F530/LF311/3310L

USA

❖

❖❖

❖ FCC Requirements

1. This equipment complies with Part 68 of the FCC rules. On the cover of this equipment is a label

that contains, among other information, the FCC registration number and ringer equivalence

number (REN) for this equipment. If requested, this information must be provided to the tele-

phone company.

2. This equipment uses the RJ11C USOC jack.

3. A plug and jack used to connect this equipment to the premises wiring and telephone network

must comply with the applicable FCC Part 68 rules and requirements adopted by the ACTA. A

compliant telephone cord and modular plug is provided with this product. It is designed to be

connected to a compatible modular jack that is also compliant. See installation instructions for

detail.

4. The REN is used to determine the number of devices that may be connected to a telephone line.

Excessive RENs on a telephone line may result in the devices not ringing in response to an in-

coming call. In most but not all areas, the sum of RENs should not exceed five (5.0). To be cer-

tain of the number of devices that may be connected to a line, as determined by the total RENs,

contact the local telephone company.

The REN is separately shown on the label.

5. If this equipment causes harm to the telephone network, the telephone company will notify you

in advance that temporary discontinuance of service may be required. But if advance notice is

not practical, the telephone company will notify the customer as soon as possible. Also, you will

be advised of your right to file a complaint with the FCC if you believe it is necessary.

6. The telephone company may make changes in its facilities, equipment, operations, or proce-

dures that could affect the operation of the equipment. If this happens the telephone company

will provide advance notice in order for you to make necessary modifications to maintain unin-

terrupted service.

7. If trouble is experienced with this equipmet, for repair or warranty information, please contact

RICOH CORP. CUSTOMER SUPPORT DEPT. at 1-800-FASTFIX. If the equipment is causing

harm to the telephone network, the telephone company may request that you disconnect the

equipment until the problem is resolved.

8. In the event of operation problems (document jam, copy jam, communication error indication),

refer to the solving problems section in this manual.

9. Connection to party line service is subject to state tariffs. Contact the state public utility commis-

sion, public service commission or corporation commission for information.

❖

❖❖

❖ WHEN PROGRAMMING EMERGENCY NUMBERS AND/OR MAKING TEST CALLS TO

EMERGENCY NUMBERS:

1. Remain on the line and briefly explain to the dispatcher the reason for the call before hanging

up.

2. Perform such activities in the off-peak hours, such as early morning hours or late evenings.

CANADA

This product meets the applicable Industry Canada technical specifications.

The Ringer Equivalence Number is an indication of the maximum number of devices allowed to be con-

nected to a telephone interface. The termination on an interface may consist of any combination of de-

vices subject only to the requirement that the sum of the RENs of all the devices does not exceed five.

In accordance with IEC 60417, this machine uses the following symbols for the main power switch:

a means POWER ON.

b means POWER OFF.

StellaF15_EN_Combine_F1_Pre_FM.book Page 1 Friday, August 27, 2004 6:22 PM