Service manual

4.3 CLEANING BRUSH REPLACEMENT
1. Remove the cleaning blade [A]. (See Cleaning Blade
Replacement.)
2. Remove the screw of the rear cleaning side bracket [C] and pull
out the cleaning brush [B] together with the cleaning side bracket
(1 E-ring) and gear [D].
3. Remove the gear and the rear cleaning side bracket, and replace
the cleaning brush.
NOTE:a) Do not touch the cleaning brush surface. Handle only
the shaft-ends.
b) Do not bend or damage the entrance seal.
c) This screw [E] is a tapping screw. Do not tighten it too
much as this will strip the resin threads.
[B]
[C]
[E]
[D]
[A]
FSM 5-31 FT5733/5433