Service manual

4.6 ENTRANCE SEAL REPLACEMENT

1. Remove the cleaning unit and the following parts:

Cleaning Blade

Cleaning Brush

2. Remove the used toner. (See Used Toner Collection.)

3. Clean the cleaning unit with a vacuum cleaner.

4. Remove the entrance seal [A] together with the strip of 2 sided

tape securing it to the lower casing.

5. Clean the lower casing [B] with alcohol: make sure that no tape

remains on the casing surface.

6. Place a new strip of 2-sided tape [C] on the lower casing surface.

The upper edge [D] of the tape must be flush with the edge [E] of

the projection as shown in the illustration.

7. Place the new entrance seal on the 2-sided tape as shown in the

illustration.

NOTE:a)The lower edge [F] of the entrance seal must be aligned

with the edge [G] of the lower casing.

b) Make sure that there are no waves in the upper edge

[H] of the entrance seal.

8. Place the new seal [I] on the entrance seal.

[A]

[B]

[D]

[I]

[H]

[C]

[I]

[D] [E]

[F]

[G]

3±1

1±1

4±1

FT5733/5433 5-34 FSM