Service manual

5.4 PAPER FEED CLUTCHES REPLACEMENT
< Common Procedure>
1. Turn off the main switch and unplug the power cord.
2. Remove the rear cover.
3. Swing out the main control board assembly (1 screw).
(1) By-pass Feed Clutch
1. Remove the by-pass feed clutch [A](1 E-ring, 1 connector, and 1
wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch
stopper groove engages with the stopper bracket [B].
(2) Relay Feed Clutch
1. Remove the relay feed clutch [C] (1 E-ring, 1 connector, and 1
wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch
stopper groove engages with the stopper bracket [D].
(3) Upper Paper Feed Clutch
1. Remove the stopper bracket [D] (1 screw).
2. Remove the upper paper feed clutch [E] (1 E-ring, 1 connector,
and 1 wire saddle).
NOTE: When reinstalling the clutch, make sure that the clutch
stopper pin [F] engages with the groove of the stopper
bracket.
[D]
[F]
[E]
[C]
[A]
[B]
FSM 5-41 FT5733/5433