Service manual

5.5 REGISTRATION CLUTCH REPLACEMENT
1. Turn off the main switch and unplug the power cord.
2. Remove the rear cover.
3. Take the high voltage cables off the hooks on the exhaust blower
housing.
4. Remove the exhaust blower assembly [A] (2 screws and 1
connector).
5. Remove the exhaust blower bracket [B] (1 spring [C] and 1
screw).
6. Remove the stopper bracket [D] (1 screw).
7. Remove the registration clutch [E] (1 E-ring, 1 connector, 1 wire
saddle).
NOTE: When reinstalling the clutch, make sure that the clutch
stopper pin [F] engages with the groove of the stopper
bracket.
[A]
[D]
[B]
[C]
[F]
[E]
FSM 5-43 FT5733/5433