Service manual

5.6 TRAY LIFT MOTOR/TRAY REPLACEMENT

1. Turn off the main switch and unplug the power cord.

2. Remove the lower tray from the copier. (see paper tray removal)

3. Remove the rear cover and swing out the main control board and

the dc power supply board assemblies (1 screw each).

4. Take the high voltage cables off the hooks on the exhaust blower

housing.

5. Remove the exhaust blower assembly (2 screws and 1

connector).

6. Remove the high voltage supply board assembly from the copier

base plate (1 screw, 3 wire saddles, 6 connectors).

7. Pull out the paper lift motor assembly [A] from the copier (2

screws, 3 connectors, 3 wire saddles).

8. Remove the tray lift motor [B] (2 screws).

[A]

[B]

FT5733/5433 5-44 FSM