Service manual

6.2 DRUM REPLACEMENT
1. Pull out the drum unit from the copier and place it with the left
side down on a clean sheet of paper (see Drum Unit Removal).
2. Loosen the two screws [A] securing the bearing holder [B] and
rotate the holder as shown.
3. While holding the front side of the drum unit, push the rear end of
the drum [C] towards the front to loosen the bearing [D].
4. While holding the front and rear ends of the drum, remove the
drum from the drum unit by lifting it up.
5. Remove the bearing and the bearing screw [E] from the old drum
and install them on a new drum.
NOTE: Keep the drum protective sheet on the new drum.
6. Clean the ID sensor and the V sensor with a blower brush (see
ID sensor Cleaning and Replacement, V sensor cleaning and
Replacement).
7. Clean the toner shield glass and the green filter (see Toner
Shield Glass Cleaning and Replacement).
[A]
[D]
[E]
[C]
[F]
[B]
[E]
[D]
FSM 5-51 FT5733/5433