Service manual

6.3 PICK-OFF PAWL REPLACEMENT
CAUTION: Be careful not to injure your hands with the pick-off
pawls as the top of them is very sharp.
1. Remove the drum from the drum unit (see Drum Replacement)
and keep the drum wrapped in the protective sheet or a clean
sheet of paper.
2. Remove the cam gear shaft [A] (1 screw) and the cam gear [B].
3. While turning the pick-off pawl assembly towards the drum side,
slide it to the rear. Lifting the front side of the assembly, remove it
from the drum unit.
4. While releasing the shaft stopper [C], pull out the pick-off pawl
shaft [D] from the assembly.
NOTE: Be careful not to lose the pick-off pawl springs [E].
5. Install the new pick-off pawls [F] on the pick-off pawl holder and
set the pick-off pawl springs.
NOTE: a) Make sure that the pick-off pawls are positioned
correctly on the pick-off pawl holder [G].
b) Make sure that the pick-off pawl shaft is locked by the
shaft stopper.
6. Reassemble the drum unit.
[C]
[D]
[F]
[G]
[E]
[B]
[F]
[A]
FSM 5-53 FT5733/5433