Service manual

7. Run the V sensor harness [A] and the drum grounding wire [B] on
the drum unit frame as shown and install the front drum cover.
NOTE: Make sure that the harnesses are correctly positioned and
that no wire is nicked or pinched by the drum front cover.
8. Reassemble the drum unit and install all the removed units in the
copier.
NOTE: When reinstalling the ID/V sensor bracket, make sure that
the spurs [C] are correctly positioned as shown.
9. Perform the ID/V sensor adjustment (see ID Sensor and V
Sensor Adjustment SP54).
[B]
[A]
[C]
[A]
[B]
FT5733/5433 5-56 FSM