Service manual

6.6 TONER SHIELD GLASS AND GREEN FILTER
CLEANING
1. Remove the drum unit from the copier (see Drum Unit Removal)
and place it on a clean sheet of paper with the drum unit top
plate up [A].
2. While holding the front side of the drum unit, slide the drum unit
top plate to the rear and remove.
3. While holding both the front and rear ends of the toner shield
glass [B] with your fingers, lift the glass up.
4. Clean the toner shield glass and the green filter [C] on the drum
unit top plate with a dry cloth.
NOTE: a) After cleaning the green filter, discharge static electricity
on the filter by touching it with your finger.
b) Do not clean the green filter with water or any other
cleaning solution as the filter has an antistatic coating.
5. Reassemble the drum unit.
NOTE: When reinstalling the drum unit top plate, be careful not to
nick or pinch the erase lamp unit harness.
[B]
[C]
[A]
FSM 5-57 FT5733/5433