Service manual

6.7 ERASE LAMP UNIT REPLACEMENT
1. Remove the drum and the toner shield glass from the drum unit
(see Drum Replacement and Toner Shield Glass Cleaning).
2. While unhooking the positioning pawls [A], remove the erase
lamp unit [B] (1 connector) as shown.
3. Couple the erase lamp connector [C] with a new erase lamp unit
and install the unit in the drum unit.
NOTE: Make sure that the erase lamp unit is hooked correctly
with positioning pawls and the harness is set in position.
4. Reassemble the drum unit.
NOTE: When reinstalling the drum unit top plate, be careful not to
nick or pinch the erase lamp unit harness.
5. If you have replaced the erase lamp unit with a different type
(standard type and edit type), set SP84 (Editing Eraser) to
correct the setting for the type of lamp installed.
[C]
[B]
[A]
FT5733/5433 5-58 FSM