Service manual

6.14CHARGE GRID PLATE REPLACEMENT
1. Remove the wire cleaner from the charge corona unit.
2. Unhook the grid anchor plate [A] from the hook on the front end
block, and lift up the grid anchor plate as shown.
NOTE: When unhooking the anchor grid plate, be careful not to
break off the hook [B].
3. Remove the old grid plate [C] from the charge corona unit.
4. Set a new grid plate on the rear hooks [D] first, then on the front
hooks of the anchor plate by closing the anchor plate.
NOTE: a) Do not touch the charge grid plate with oily bare hands.
b) Do not bend the charge grid plate, or make any dent on
it, to avoid uneven charge.
[D]
[C]
[A]
[B]
FT5733/5433 5-66 FSM