Service manual

6.15TRANSFER/SEPARATION CORONA WIRE
REPLACEMENT
1. Lower the T & S corona unit and remove it from the copier.
2. Remove the paper guide [A] from the T & S corona unit by lifting
the rear part and sliding it to the rear.
3. Remove the front and rear end block covers [B] (2 hooks each).
NOTE: When removing the end block covers, be careful not to
break off the side hooks.
4. Remove the wire hook cover [C] from the rear end block.
5. Unhook the corona wire tension springs [D] and remove the
transfer and separation corona wires.
NOTE: Be careful not to damage or lose the tension springs.
[A]
[B]
[C]
[B]
[D]
FSM 5-67 FT5733/5433