Service manual

7.3 HOT ROLLER REPLACEMENT
1. Remove the fusing lamp (see Fusing Lamp Replacement).
2. Press both "B2" release levers [A] and lower the fusing exit
assembly [B].
3. Remove the front and rear pressure springs [C].
4. Remove the fusing thermistor [D] (1 screw).
5. Remove the front and rear C-rings [E], 4 gears [F, G, H, I], front
and rear collars [J], front and rear fusing bearings [K], and then
remove the hot roller [L].
NOTE: a) Lubricate the roller shaft [M] and bushing [N] with
BARRIERTA L55/2 grease
b) Peel off 3 cm (1 inch) from both ends of the protective
sheet, and install the hot roller.
c) Before setting the pressure springs, remove the rest of
the protective sheet.
d) Lubicate the fusing drive gears and their shafts with
grease G501.
Rev. 1/94
[F]
[H]
[I]
[G]
[E]
[E]
[J]
[K]
[D]
[C]
[A]
[B]
[L]
[G]
[K]
[J]
[F]
[E]
[N]
[M]
[N]
FSM 5-71 FT5733/5433