Service manual

7.4 PRESSURE ROLLER REPLACEMENT

1. Remove the hot roller (see Hot Roller Replacement).

2. Remove the upper fusing entrance guide [A] (2 screws).

3. Remove the lower fusing entrance guide [B] (1 screw) as shown.

4. Remove the front lamp holder (1 screw).

5. Lift the front end of the pressure roller [C] and slide, along with its

bearings, out the front side of the unit.

6. Remove the front and rear bearings and the fusing knob [D] (1

screw).

7. Replace the pressure roller.

NOTE:When installing a new pressure roller:

a) Lubricate the roller shaft [E] and bearings [F] with

BARRIERTA L55/2 grease.

b) Lubricate the fusing drive gears and their shafts with

grease G501

[A]

[C]

[B]

[D]

[F]

[E]

FT5733/5433 5-72 FSM