Service manual

5. Unhook the lift spring [A] from the duplex lift lever [B] and the
cam clutch [C].
6. Remove 3 clamps [D] with a pair of pliers.
7. Disconnect CN602, and CN603 [E] from the duplex control board.
8. Disconnect the sensor connector [F] from the jogger home
position sensor.
9. Disconnect the connectors [G, H] from the duplex turn gate
solenoid and from the duplex entrance sensor.
10. Remove the duplex unit [I] (4 screws) from the tray.
NOTE:Hold both sides of the duplex unit frame when lifting the
duplex unit out of the tray.
[I]
[A]
[B]
[E]
[D]
[G]
[H]
[D]
[F]
[C]
FSM 5-79 FT5733/5433