Service manual

-Installation-
1. When placing the duplex unit back into the tray, hold up the
bottom plate [A] so that the flipmylar brackets [B] fit under it as
shown.
2. Hook the lift spring [C] to the cam clutch [D] and the duplex lift
lever [E] as shown.
NOTE:When installing the duplex unit, make sure of the
following:
a) The positioning pin [F] fits through hole [G] in the side
plate.
b) The positioning rib [H] fits through the cutout [I] in the
side plate.
c) The sensor harness [J] is not caught under the unit
frame.
[D]
[E]
[G]
[B]
[I]
[J]
[F]
[H]
[A]
[C]
[G]
FT5733/5433 5-80 FSM