Service manual

8.2 DUPLEX FEED ROLLER REPLACEMENT
1. Open the front door.
2. Pull out the duplex tray.
3. Remove the side inner cover [A] and front inner cover [B] (5
screws).
4. Raise the upper and lower paper guide plates [C] all the way up
and remove the snap ring [D] for the guide plate support arm.
5. Remove the snap ring [E] from both ends of the paper feed roller
shaft.
6. Move the front and rear bushings [F] of the paper feed roller shaft
inward and remove the paper feed roller assembly.
7. Remove the bushing, the rear stack roller [G] (1 E-ring) and rear
paper flattener [H] from the shaft.
8. Remove the duplex feed roller [I] from the shaft (1 E-ring).
9. Remove the feed roller bushing [J] from the roller and place it in
the new roller.
10. Reassemble the duplex unit.
[A]
[B]
[E]
[F]
[D]
[E]
[C]
[I]
[J]
[H]
[G]
FSM 5-81 FT5733/5433